Form 07A –Frontier V6, V4 and Extreme X8 Owner’s Manual ENGLISH.docx
Revision No.4
© Magic Mobility
Page 44 of 65
7
Bluetooth (if installed)
The LCD Joystick does NOT include a Bluetooth transmitter/receiver. You will only be able to
access Bluetooth Mode if you have an R-net Bluetooth Module installed
The R-net Bluetooth Modules allow a wheelchair user
to control a Bluetooth enabled device either through a
Joystick or via a SID connected to the R-net Omni.
Typical applications include PC mouse control or
operation of a Smart device.
Up to two Mouse Modules and one iDevice Module
may be connected enabling simultaneous control of
three Bluetooth devices, one being an iOS device.
R-net Bluetooth Module
7.1
Pairing
Bluetooth Mode is accessed via Mode selection.
While in Bluetooth Mode, the screen below will
appear
(To make a Bluetooth Module operate with a PC you
will need an aftermarket Bluetooth receiver dongle
connected and with the drivers installed)
Bluetooth Mode Screen
The Bluetooth Module must be put into Discovery Mode in order to discover new devices for
pairing.
Use the following procedure:
Operate your Input Device in the forward direction and hold until it beeps. This will take
approximately 10 seconds, then release.
Operate your Input Device in the reverse direction and hold until it beeps. This will take
approximately 10 seconds, then release.
The Bluetooth Module is now in Discovery Mode and ready to be paired with a Bluetooth device.
Once a Bluetooth Module has successfully been paired with a Bluetooth device, the module
remembers the device’s ID. This means the wheelchair user can drive outside the operating range,
turn off the control system or the Bluetooth device, and upon returning within range of the switched
on device, the Bluetooth connection will be automatically reinstated.
Once the Bluetooth device has been paired, further instructions will normally appear on your device.
More help, if required, can be found in PG Drives Technology’s manual SK79614. This manual is
available through your Magic Mobility Dealer on request.
Android Devices
A list of R-Net compatible devices can be found at
www.pgdt.com/smartdevices
and the R-Net for
Android App is available from the play store; search for “PGDT”, “R-net” or “R-net for Android”
iDevices
The R-net iDevice Module allows pairing with an iPad or an iPhone. Once paired, the iDevice Module
uses the accessibility options switch control or voice control to allow R-net input device commands
(joystick nudges) to control or access any of the applications of the iDevice.
