- Do not stick any sharp objects, such as safety pins, into the heating pad; they could damage the electrical
cables. Do not sew the heating pad with a needle!
- The heating pad must not be rolled or covered during operation. Never fold the heating pad when it is
switched on. Always make sure that, if used on a reclining bed, the heating pad is laid out flat and cannot be
rolled up or the cord caught or pinched. If it cannot be guaranteed that the above situations can occur, do
not use the heating pad on a reclining bed.
- Do not cover the heating pad or use it as a bedsheet.
- Do not place the heating pad pad under the mattress.
- Make sure that the heating pad remote control is not covered by blankets, cushions or similar objects and
is within easy reach.
- Prolonged use of the heating pad at a high level can cause burns on the skin. The heating pad should not
be used by disabled persons, children or persons sensitive to heat.
- WARNING!
The user should not fall asleep when using the heating pad.
- When the heating pad is spread out on the bed, do not let children jump on it. If they do, check thorou-
ghly that every part of the pad is in order.
- Never disassemble or repair the heating pad yourself. Tampering with the equipment will void the warranty.
- If the electric heating pad is no longer to be used, it must be turned off and disconnected from the power
source by pulling the plug of the power cable from the power outlet. Never pull the heating pad out of the
socket by the power cable while it is switched on and if your hands are wet or damp. Make sure the power
cord is not damaged.
- In case of any damage to the power cable, immediately switch off the heating pad and disconnect it from
the power source. The power cord cannot be replaced. The heating pad must be disposed of in accordance
with the applicable regulations.
- Store the heating pad folded (or twisted) not too tightly, without bending the heating element in a dry
place. Do not place heavy objects on the pad or twist it. After storage, carefully inspect the pad before further
use. Do not use the pad with a damaged power cord.
- If dirt appears on the pad, follow the instructions for cleaning the heating pad in the "Cleaning and
Maintenance" section.
OPERATION AND ASSEMBLY
INSTRUCTIONS FOR USE
- Make sure the heating pad fits your mattress and then lay it flat directly on the bed mattress to leave
room for a pillow. The edge where there is no power cord with the control belongs to the legs. The heating
pad should be firmly attached to the mattress. Make sure that the heating pad is not wrinkled or kinked.
- Make the bed.
- The pad is designed so that it can warm even the uncovered part of the bed.
- The pad should not be tucked into the sides of the bed.
- Connect the power cord with the remote controller to the heating pad, and then connect the power cord
plug to an electrical outlet (make sure the power cord is not damaged or tangled in any way).
- When the heating pad is in use, the remote controller must not be covered. Make sure it is not placed under
the heating pad, cushion or other objects, or near other heat sources, it could overheat and be damaged.
- Push the switch to position I, II or III. The LED indicator will light up, and the heating pad will start to heat
up.
- To stop heating, push the switch to position 0.
OVERHEATING PROTECTION
- The heating pad is equipped with a safety system that protects the pad from overheating and damage.
- In the event of a malfunction, the system switches the pad off and cannot be used again. In this case, an
authorised service center must be contacted.
(*) Authorized service: the manufacturer's or importer's service department or other person who is qualified,
Содержание QD(150*80)/1.0m2-SD-DT
Страница 1: ......
