User documentation MAGICFX® DMX FX Switch Pack
Page 11
10. INSTALLATION
CAUTION:
The machine can be damaged if you do not follow the procedures
carefully.
DANGER WARNING:
The MAGICFX® DMX FX Switch Pack may only be installed by adults
and authorised persons.
Ga bij het installeren van de DMX FX Switch Pack als volgt te werk:
3.
Connect a 3-pin DMX cable to the DMX
FX Switch Pack.
There should be no more than a 500m
distance between the controller and the
receiver, also no more than 32 DMX
receivers may be connected to 1 DMX
sender. Maintain these standards for a
faultless operation.
You can connect several machines by
using 3-pin DMX cables.
2.
Check if the on/off switch is in the
‘off’
position and then connect the electricity
cable. The DMX FX Switch Pack runs on
230V~ 50/60Hz. You will need a
powerCON plug to provide the DMX FX
Switch Pack with electricity.
Only use an earthed power socket!
The DMX FX Switch Pack is also
equipped with a powerCON output.
By connecting it with a powerCON loop
cable (MFX0309) you can connect several
machines to the same power source.
1.
Mount the DMX FX Switch Pack in a truss
system by means of 2 certified truss
clamps (MFX3103) or place these on an
even, solid and stable surface.
