9
INSTAllATION INSTRUCTIONS
WARNING
: Installation and service must be performed by a qualified installer, service agency or the gas
supplier� Failure to do so can result in death, fire, or electrical shock�
ImPORTANT
: Save these instructions for local electrical inspectors use� Read and save these instructions for
future use�
WARNING
: Installations for Gas and Electric
•
The cooktop is manufactured for use with Natural Gas� The cooktop can be converted for use with propane
gas using the propane conversion kit supplied with the cooktop�
•
be sure the cooktop being installed is correct for the type of gas being used�
•
Refer to the rating plate located on the underside of the burner box�
•
When connecting the unit for propane gas, make certain the propane tank is equipped with its own high
pressure regulator�
•
In addition, the pressure regulator supplied with the cooktop must be installed on the gas inlet pipe going
to the cooktop�
INSTALLING COOkTOP
1�
Use as 24” or deeper base cabinet�
2�
Cut the opening in the countertop�
To ensure accuracy it is best to
make a template for the opening�
Make sure the sides are parallel
also rear and front cuts are exactly
perpendicular to the sides� keep
in mind all minimum clearances�
(Refer to Figure 6�)
3�
before installing the cooktop into
the opening in the countertop,
remove all grates and burner caps�
4�
Turn the cooktop upside down
and place the special foam gasket
around the bottom edge of the
cooktop� It is important that the
gasket is fixed evenly without
any gaps or overlapping, this is to
prevent liquid seeping underneath
the cooktop� (Refer to Figure 7�)
5�
After the foam gasket is installed,
place the cooktop into the
countertop� (Refer to Figure 6�)
6�
Secure the cooktop from
underneath with the supplied clips
and screws� (Refer to Figure 8�)
figure 6
figure 7
figure 8
22-13/16”
(580 mm)
20” (510 mm)
19 -1/4” (490 mm)
3” (75 mm)
6” (150 mm)
22” (560 mm)
3-3/8” (85�4 mm)
Underside of Cooktop
Clip
Screw
Foam Gasket
Underside of Countertop
