14
DO NOT remove the ground prong from the power cord plug.
DO NOT use an adapter.
DO NOT use an extension cord.
Failure to do so can result in death, fire or electrical shock.
NOTE
: Before making the connection, make sure of the following.
The safety circuit breaker and the electrical system are able to withstand the load of the appliance.
The power supply system has a ground connection in good working order in accordance with the regulation.
The electrical socket should be easily accessible with the appliance installed. In all cases, the power supply lead
must be positioned so that it does not reach a temperature of 122°F above the room temperature at any point.
WARNING
:
Severe shock or damage to the cooktop may occur if the cooktop is not installed by a qualified
service technician.
WARNING
:
If for any reason a gas control knob is turned ON and there is no electric power to operate the
electronic igniter of the cooktop, turn off all gas control knobs and wait 5 minutes for gas to dissipate before
lighting the burner manually.
WARNING
:
To light the burner manually, carefully hold a lighted match to the burner ports and push and turn
the gas control knob to HI until it lights and then turn the knob to the desired setting.
Assembling the Burners
The electrode of the electronic ignition system is positioned above the surface of the burner base. DO NOT remove a
burner cap or touch the electrode of a burner while another is turned on. Damage or electrical shock may occur.
1.
Place burner heads over the burner base. Make sure the hole in the burner head is properly aligned with the
electrode in the burner base. (Refer to Figure 17.)
ELECTRICAL CONNECTION
WARNING
: Electrical Shock Hazard
ALWAYS disconnect the electrical plug from the wall receptacle before servicing this unit.
Plug into a grounded 3 prong outlet.
Figure 18
Not Properly
Seated
Properly
Seated
2.
Place the burner caps on the burner
heads. Make sure the burner caps are
properly seated on the burner head.
(Refer to Figure 18.)
3.
Operation of the electric ignitors
should be tested after the cooktop and
supply line have been carefully checked
for leaks and the cooktop has been
connected to the electrical power.
To check igniters, push and turn a burner
valve to the light positon. All sparks will
make a series of sparks, but only the
burner turned to LITE with light.
Figure 17
Burner Cap
Burner Head Assembly
Electrode
Burner Base
