8
Figure 1
OPERATING INSTRUCTIONS
MAKING COFFEE MANUALLY
1.
Open the water tank cover and fill to the mark with
clean water.
2.
Add desired amount coffee grounds to nylon filter
according to taste, then set nylon filter into funnel.
3.
Close the water tank cover and plug in the coffee
maker. Display will show 12:00.
4.
Put carafe on the warming plate, making sure that it is lined up with funnel.
5.
Press the “On/Off” button once and the red indicator light will illuminate. After a short while water will
start to drip through the coffee maker.
6.
When the brewing is completed, the coffee maker will go into a “Keep Warm” mode and then turn off after
2 hours.
NOTE
: You can remove the carafe at any point in the brewing cycle to pour a cup of coffee, but be sure to put
back in place under the funnel within 30 seconds.
SETTING THE CLOCK AND AUTOMATIC BREWING
The coffee maker can be programmed to automatically begin brewing coffee at a preset time by doing the
following:
1.
Press the “PROG” button once and “CLOCK” will appear on the display.
2.
Use the “HOUR” and “MIN” buttons to set the current time. Make sure to set AM/PM for the time.
3.
Press “PROG” button to save the current time setting and the display shows “TIMER”.
4.
Use the “HOUR and “MIN” buttons to set the desired automatic start time.
5.
Press the “On/Off” button twice. The blue light will come on, and unit will begin brewing coffee at the
pre-set time that was entered. When brewing starts, the red light will turn on.
WARNING
: DO NOT leave the coffee maker unattended while it is brewing.
