Maggi BS 46, Оригинальное руководство по эксплуатации и техническому обслуживанию

Страница: 25 / 56

Page
21
GREASING DRILLING HEAD PROCEDURE
The greasing operation of the spindle holder head must be carried out when the unit is hot so that the grease
inside is more fluid.
1. remove the screw (A) so that there is a open hole in the head cover
2. Use EP2 type grease, insert the pump into the grease fitting (B) and add a small amount of lubricant
3. Switch on the machine and let the spindles turn so that the grease goes all around the gears in the head
4. Switch off the machine
5. Verify if some grease has leaked out of the hole (position A); if not, please, repeat the whole procedure once
again and until the grease is leaking out
6. Lock the head cover back to the head by inserting the washer and screw in place ( A )
CLEAN AND LUBRICATE GUIDES, SLIDING RODS AND MOVING SCREWS