Magellan MG6250, Руководство по программированию раздела

Страница: 53 / 56

MG6250 • Section Programming Guide
Version 1.6 Appendix A: EN 50131 Programming | 53
Wireless Module Options
General Options
Section
Option Description
OFF ON
[2004]
1 Future use - -
2 Report Zone restore

On bell cut-off


On zone closure
3 & 4
Tamper recognition options (console tamper follows this option) 3 4
Disabled OFF OFF
Trouble only OFF ON
Disarmed: Trouble only
Armed: Follow zone’s alarm type
ON OFF
Disarmed: Audible alarm
Armed: Follow zone’s alarm type
ON ON
5 Generate tamper trouble if detected on bypassed zone


Disabled

Enabled
6 & 7
Wireless transmitter supervision option 6 7
Disabled OFF OFF
Trouble only OFF ON
Disarmed: Trouble only
Armed: Follow zone’s alarm type
ON OFF
Disarmed: Audible alarm
Armed: Follow zone’s alarm type
ON ON
8 Generate supervision trouble if detected on bypassed zone


Disabled

Enabled
Section
Option Description
OFF ON
[2009]
1 Restrict Arming when zone opens during exit delay

Disabled


Enabled
2 Acknowledge Trouble(s) before Arming

Disabled


Enabled
3 Future Use - -
4 Future Use - -
5 Future Use - -
6 Future Use - -
7
GSM Antenna*


Internal

External
8
RF Frequency**


868 MHz

433 MHz
* If you are using a GPRS14 on an 868 MHz console, you cannot use GSM as a communication method when armed, unless an external antenna is connected.
Once the antenna is connected, you must set section
[2009] , option [7] to ‘ON’, or ‘external’.
** The frequency of the console cannot be changed, but must be programmed accordingly. Refer to the sticker on the console to view the set frequency, then
program it in option [8].