MAGBEAST 5, Инструкции по безопасности и руководство оператора

Страница: 9 / 17

MAGBEAST 5
Operator’s manual for MAGBEAST 5 Drilling Machine
- 4 -
Visually check the machine for damage.
Machine must be checked before operation for any signs of damage that will affect the operation of the machine.
Particular notice must be taken of the mains cable, if the machine appears to be damaged it should not be used
failure to do so may cause injury or death.
Check operation of the machine.
The machines operation must be checked to ensure that all components are working correctly.
Machines Carbon Brushes.
The Machines Brushes should be checked to make sure there is no abnormal wear present. This should be
checked at least once a week if used frequently. If the brush has worn more than 2/3 the original length the
brushes should be changed. Failure to do so m ay cause damage to the machine.
Machines Magnetic base.
Before every operation the magnetic base should be checked to make sure that the base is flat and there is no
damage present. An uneven magnet base will cause the magnet not to hold as efficiently and may cause injury to
the operator.
Adjustment of slide and bearing bracket Alignment.
An essential requirement of the machine is that the slide can move in a smooth and controlled manner, free of
lateral movement and vibration.
This situation can be maintained by periodic adjustment of the slide and is acco mplished.
Check machines grease.
The gearbox grease should be checked once a month to ensure all moving components are covered to prevent
wear. The grease should be changed at least once a year to ensure you gain the best from the machine.
Check Armature of the machine.
This should be checked at least 1 per month to see that there are visual signs of damage to the body or to the
commutator. Some signs of wear will be seen on the commutator over a period of time. This is normal as this is
the part that comes in contact with the brushes but any signs of abnormal damage and the part should be
replaced.