MAGBEAST 5, Инструкции по безопасности и руководство оператора

Страница: 7 / 17

MAGBEAST 5
Operator’s manual for MAGBEAST 5 Drilling Machine
- 2 -
Use of Cutting Fluid
Magbeast 5 has 5 Morse Taper spindle drilling. To be used with metal cutters,
there is a necessity to use a 1.1/4’’ adapter. For this use the 1 1 / 4 ”Weldon
shank is the most common. This shank has a dimension of Ø31, 75 x 60mm
and has two surfaces for the locking screws.
When using large cutter dimensions, it is extremely important that the cutter is
properly fastened in the adapter before drilling begins. Incorrect attachment can
cause damage to cutter and adapter. Always make sure to use the following
procedure to fasten the cutter:
•
Always disconnect the power supply when you change cutter or doing
adjustments to the machine.
•
Insert cutter with pilot into the spindle. Make sure that the two locking
surfaces are appropriate in relation to the 2 screws. Press the cutter
completely skank completely into the adapter.
•
First tighten one single screw gently so that the screw turns the cutter
into position. Help rotating the cutter if necessary.
•
Tighten the screw, release and tighten the screw again.

Tighten the second screw properly.

Then after tightening the first screw again.
1 ¼” Weldon Shank