MANUAL DE INSTRUCCIONES / INSTRUCTION MANUAL
Installation and Operation
Controls and Indicators
As shown above, the container’s controls are located on the door. They include:
- A digital regulator, which enables the working temperature to be displayed
and regulated at all times.
- An illuminated On/Off switch.
- A removable fuse-holder.
Placement
Site the Z-450 away from sources of strong heat or cold, and out of direct sunlight. There should
be sufficient space around the container to allow for good circulation of air behind the machine, as
this is necessary to ensure adequate refrigeration of the condenser circuit.
To prevent vibrations and intrusive noise, make sure the machine is sitting perfectly flat on the
floor or work surface.
Warning
: Heavy machine; handle with care.
Connection to the Electricity Supply
The machine is fitted with a cable for connection to the power supply, located at the rear next to
the compressor.
Important:
Make sure the voltage of the electricity supply matches that indicated on the
container’s specification plate. For the safety of the device and its operators, it is vital
that it be earthed correctly in accordance with the Regulations for Low-Voltage Electrical
Equipment.
The manufacturer shall not be held liable for any claims in the event that these safety
measures are not adopted.
In the event of a power surge, short-circuit or excess consumption the Z-450’s fuse will
blow. It must be replaced with an equivalent item once you have identified and solved the
problem.
To replace the fuse (the Z-450 is supplied with an instruction manual and replacement fuse),
switch the machine off and unscrew the fuse-holder cap anticlockwise. Remove the sheath
(with the fuse inside), replace the blown fuse with the new one, then insert the sheath back
into the holder and screw the cap back on clockwise. A replacement fuse is included, along
with the instruction manual.
