A A / A A A F l a s h l i g h t
MM Rev.1 8/03
421-000-439
6
STEP 3
Remove the LAMP (8) by pulling it straight
out of the receptacles. A spare LAMP (8) is
located in the TAIL CAP (20).
STEP 5
Place the TOOL (23) and the BARREL (12) in
the tool base and push down on the
BARREL (12). The UPPER INSULATOR (11)
will move upward and separate from the
LOWER INSULATOR (15).
STEP 6
You can now remove the UPPER
INSULATOR (11) from the BARREL (12).
STEP 4
Insert the end of the SWITCH REPAIR TOOL
(23) with the longest pin protrusion into the
bottom of the BARREL (12). Rotate the tool
until the two pins enter the two holes in the
bottom of the LOWER INSULATOR (15).
(Note: The SWITCH ASSEMBLY (22) may
tend to rotate, if so place your finger on it
prior to rotating the tool).
