-21-
4
Setting / Adjustment
4.1
Assembly
Pay attention that the container's two snap locks
have safely engaged in the recesses on the
motor hood.
Push the suction hose fitting over the
container's suction opening and turn it until the
hose fitting engages.
4.2
Mains connection
The dust extractor S 35 M is equipped with protective
earthing acc. to class I and may therefore only be
connected to sockets with protective earth conductor.
Prior to commissioning make sure that the mains
voltage agrees with the operating voltage stated on
the machine's rating plate.
4.3
Changing the folded filter cartridge
Shake off the folded filter cartridges before
changing the filter.
Using a coin or similar object, turn the catch 7
(fig. 1) on locking bolt 9 anticlockwise by 90°
and push the locking bolt 9 to the rear.
Swing open the hood and remove the filter
cartridge 5 (fig. 5) towards the top.
Immediately seal the removed folded filter
cartridges in a dust-tight plastic bag and dispose
of in accordance with the instructions.
Insert the new filter cartridges and pay attention
to a neat and tight fit of the filters.
Fold down the hood and return to its initial
position by slightly pressing on the locking bolt 9
(fig. 1). The device is now once more closed.
4.3.1
Changing the motor protection filter
The folded filter cartridges are located next to the
motor protection filter 6 (fig. 2). If they are heavily
soiled, rinse out and reinsert in dry condition.
Damaged motor protection filters must be replaced.
4.4
Changing the filter bags
Danger
This device may contain hazardous
dust. Emptying and maintenance
operations including the disposal of
dust collection containers may only
be carried out with appropriate
protective equipment.
The filter bag must be changed if the control display
blinks during operation and an additional acoustic
signal is sounded.
4.4.1
Changing the non-woven filter bag
Switch off the device to change the non-woven
filter bag.
Pull the dust extractor's plug.
Open the snap locks 10 (fig. 1).
Detach the upper part of the dust extractor from
the container 12 (fig. 4).
Pull the filter bag carefully from the intake port.
Close the flange of the filter bag by turning down
the cover.
4.4.2
Changing the PE-discharge and disposal
bag
PE-discharge and disposal bag: Switch on dust
extractor, shake off folded filter cartridges.
Switch on dust extractor.
Wear mouth guard.
Remove suction hose, close intake port with cap
14 (fig. 6).
Open lateral locks, remove top part. Before
putting down the top part, switch on at switch
position >IR< so that possibly released airborne
particles are extracted.
Carefully seal PE-discharge and disposal bag
with the enclosed sealing tape.
Pull flange carefully off the intake port and
close.
Carefully remove PE-discharge and disposal
bag from the container.
Dispose of extracted material in accordance
with the legal provisions.