-20-
6
Troubleshooting
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
7
Optional accessories
➤
Guide track, cpl.
Ref. No. 201 546
The determination of the causes of existing defects and their elimination always require
increased attention and caution. Pull out the mains plug beforehand!
Defect
Cause
Elimination
Machine cannot be switched on
No mains voltage
Check power supply
Carbon brushes worn
Take the machine to a MAFELL cus-
tomer service shop
Machine stops while cutting is in proc-
ess
Motor protection reacted
See section 4.3
Mains failure
Check power supply
Burn marks on kerfs
The cutter used is unsuitable for the
task or blunt
Replace the cutter; change reversible
knives
Chip ejection blocked
Wood is too damp
