Maeda LC785M-8B, Руководство по эксплуатации, Страница: 37 / 401

BE CAREFUL OF TIPPING ON UNSTABLE GROUND
Always observe the followings to prevent serious injuries and fatal accidents when travelling over
unstable ground for any reason.
•
Do not enter any soft ground area. The Machine is difficult to remove from this type of ground.
• Ground near a cliff, roadside or a deep gully may be unstable, so avoid going near such ground as
much as possible.
The Machine may tip or fall when the ground loosens due to mass and/or vibration of the Machine. Be
especially careful that the ground may have loosened after rain, use of dynamite or earthquake.
• Avoid going near earth fills or the vicinity of excavated gutters that are instable.
Crumbling caused by mass and/or vibration of the Machine may cause the Machine to tilt.
CAUTIONS WHEN SNOW COVERED OR FROZEN
Always observe the following to prevent serious injuries or fatal accidents when travelling over snow
covered ground or frozen roads for any reason.
•
Snow covered ground and frozen roads can cause slips even when the inclination is slight, so
decrease the speed when travelling and avoid starting, stopping, and swinging suddenly. Uphill and
downhill are especially likely to cause slips and thus dangerous.
• The ground of a frozen road becomes soft when the air temperature rises and causes the Machine
travel and other operations to be unstable. Be very careful.
• During cold weather, check that the load to be hoisted is not frozen or stuck to the ground or any other
surface. Attempting to hoist without knowing the load is frozen or stuck to the ground or other surfaces
is dangerous.
• Do not touch the metal surface with any part of your body, such as a finger or hand during cold
weather.
Attempting to contact a metal surface of the Machine under harsh cold weather may cause the skin to
stick to the metal surface.
• Remove snow and/or ice from the Machine that causes the safety nameplates to be hard to read. Be
especially careful to remove ice or snow that is on the boom and may fall.
CAUTIONS WHEN PARKING
• Park the machine on firm, level ground.
• Select a place where there is no hazard from falling rocks,
landslides, or of flooding if the land is low.
• Set the Machine to the travelling posture shown in the right
diagram.
• Fully lower and retract the boom.
•
Fix the hook block to the containment position.
When parking for a short time, secure the hook block to the stowage
position below the boom tip. For longer periods of parking, secure it
to the regular stowage wire rope at the front of the upper structure.
• Where it is un-avoidable to park the machine on a slope, strictly
observe the following:
•.
Fully lower and retract the boom
• Fix the hook block to the containment position.
When parking for short periods, secure the hook block to the
stowage position below the boom tip. For longer periods of parking,
secure it to the regular stowage wire rope at the front of the upper
structure.
• Set the front of the machine (blade) on the downhill side. Then dig
it into the ground.
• Put blocks under the tracks to prevent the machine from moving.
• When you leave the machine, strictly observe as follows:
• Set lock lever (1) to LOCK position (L), and then stop the engine.
• Always remove the key, take it with you, and leave it in the
specified place.
2-15