EN
10
English
Description Of Status LED Codes
Reset To Factory Default Settings
In rare cases, you might need to do a reset to factory default settings:
Step 1) Disconnect all connections from the device (power, data, DMX).
Step 2) Use a suitable tool to press the reset button (between
'DMX 1'
and
'2'
).
Step 3) Continue to press the reset button and supply power again over
'Power'
or USB.
Step 4) Continue to press the reset button and wait until all status LEDs
of the device flash repeatedly or wait 10 seconds.
Please note:
Simply repeat these steps should the process fail.
S
tatuS
S
tatuS
LED P
owEr
Powered off
Power not connected.
The device has no power.
Permanently
green
Connected to power.
The power is on.
Blinking
green
Bootloader activated.
Reset device / upload firmware.
S
tatuS
S
tatuS
LED uSB
Powered off
USB not connected.
Red
+
blinking
green
Communicating over USB.
Sending or receiving data over USB. The USB port works.
Fading between
red
+
green
Connected to USB; Drivers installed correctly.
No data is sent over USB.
Orange
Connected to USB; No drivers installed.
Reinstall software and drivers or try a different USB port.
S
tatuS
S
tatuS
LED DMX 1
S
tatuS
LED DMX 2
Powered off
No data is sent.
No data is sent.
Blinking
green
Sending or receiving data.
The DMX port works.
Sending or receiving data.
The DMX port works.
S
tatuS
S
tatuS
LED
S
E
thErnEt
P
ortS
Green
off
10 MBit/s connected.
Green
on
100 MBit/s connected.
Orange
on
Network connected.
Orange
blinking
Sending or receiving data.
The Ethernet port works.
