MADRIX PLEXUS, Руководство пользователя

Страница: 14 / 299

MADRIX PLEXUS User Manual / Handbuch 14
© 2013 inoage GmbH
DMX-IN input will be send over Art-Net to the configured Art-Net
universe via Broadcast according to the configured IP address and
Subnet mask of the device (Art-Net Remote).
Input can also be data from "Test Sending" ( see below ).
Input can also be the data sent by the SD card for Stand-Alone Mode.
In this way, Art-Net Stand-Alone can be configured. This means, the
PLEXUS runs a Stand-Alone show and the data is sent over network
(via Art-Net) directly to the LED fixtures or you could convert the data
to DMX again using a signal converter.
You may change the settings in this menu, on the device ( How To Edit
Values ).
You can also configure the settings in the PLEXUS Configuration dialog
using MADRIX. For more information, see Managing Devices Further .
For more information about Art-Net output, see the chapter Art-Net
(Output) .
For more information about Art-Net Remote, see the chapter Art-Net
Remote (Input) .
Sync Navigate to the menu 'Network' 'Sync' .
This menu shows the current settings regarding Master-Slave
Synchronization.
You can check the Sync type ('Master', 'Slave', 'Off') and Sync group (1
-256).
Also, choose if 'Intensity' ('Enabled', 'Disabled'), 'Intensity
Group' ('Enabled', 'Disabled'), 'Speed' ('Enabled', 'Disabled') and
'Freeze' ('Enabled', 'Disabled') should be synchronized for Slave devices.
For more information, see Managing Devices Further .
You may change the settings in this menu, on the device ( How To Edit
Values ).