Taurus LAN User Guide
7. Mount the drive with two screws on
each side.
8. Slide the inner enclosure back into the
outer chassis.
9. Fasten the four screws to finish the
assembly.
Note: Be careful not to damage any cables or components, and make sure the cables are
connected firmly.
Fan Speed Settings
The jumper at J4/J5 can be used to set the mode for the fan speed. You can set it to
"AUTO" and the fan speed will automatically be adjusted according to the temperature
(thermal sensor needs to be connected) or you can manually set it to use low or high
speed.
Following are the settings you can use:
•
Jumper on J4 = AUTO
•
Jumper on J5 = Manual/High Speed
•
No jumper at all = Manual/Low Speed
Page 5 / Chapter 2 - System Setup
