MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support
6
MAOM-37447 Quad 24G/26G CDR with Integrated EML Driver Evaluation Module User Guide
Rev -
User Guide
DC-0014098
2.0 Software Operation
2.1
Software Setup
Before using the EVM, install the control software on the host PC from the USB drive or EVM CD that shipped with
the EVM kit into the host PC. Copy the software files to the desired location on the host PC, then double click on
the setup.exe file to install the control software.
1. Insert the EVM CD or USB flash drive into the computer that will be used as the controller for the EVM. Locate
the “\Software\EVM Setup vX.X” folder and launch
Setup.exe
to install the software. Please note that Windows
XP Service Pack 2 is the minimum system requirement for this software.
2. Connect a USB cable to the EVM and the PC. When the USB cable is connected, a new hardware found
window may pop up and install the USB driver. Allow this process to complete before proceeding.
3. Launch the M37047 EVM User Control software by going to Start > All Programs > MACOM Technology
Solutions.
4. Once the software is running, click the “Connect” button in the top-left corner of the screen. Most settings will
be auto-detected, but you will be prompted if additional information is required.
5. Once connected, the software will display the current state of all device settings. The user can choose to adjust
settings using the “Device Settings” tab, the “Memory Map” tab, or the “Direct Register Access” control.
