PG450 IM Issue 3 © 2017 Page 2
Battery Disposal
Grease Gun Operation
Installing Grease Cartridge
WARNING
DO NOT
attempt to open the battery pack.
ONLY
charge the battery with the charger provided.
NOTE:
Dispose of depleted batteries
Pr o p e r l y. T h e b a t t e r y c o n t a in s
rechargeable Lithium-ion and must be
recycled or disposed of properly. Please
refer to the local authorities for the
correct method of battery disposal.
DO NOT
incinerate the battery pack. The battery can
explode in a fire
DO NOT
attempt to disassemble any battery.
Charge Battery
NOTE:
Charger is a fast recharge type charger.
Insert the small plug on the end of the charger lead
into the pug hole on back of the battery. A red light
indicates the battery is charging. When the battery is
fully charged the red light turns yellow.
The battery can be charged:
a) Attached to the grease gun
b) Removed from the grease gun.
To remove battery from the grease gun, press the
blue button on back of battery and slide battery out
of the rear of the gun.
DO NOT
force battery if fitting or removing from gun.
Replace battery into grease gun, by carefully aligning
the battery to the cavity on the gun, slide battery in,
until the battery locks into place.
Visually inspect the Grease Gun prior to use for
damaged, loose, or missing parts. If equipment is
worn or damaged, contact an authorized service
center for damage assessment and repair.
2) Pull the follower rod back until the rod groove can
be pulled into the barrel slot.
3) Remove the large end cap from the cartridge.
4) Slide the large open end first into the barrel.
5) Remove the small end cap from the cartridge.
6) Screw the barrel onto the gun body assembly.
7) Unlock the follower rod from the barrel.
8) Lock follower rod (Fig 2), and apply light pressure
on the pull handle (Fig 3), at the same time press the
top of the bleeder valve.
9) Pull the trigger. If grease does not appear at the
coupler repeat step 8.
Note: Rotate the barrel
counter clockwise to re-
move. Turn clockwise to
tighten.
1) Unscrew and remove barrel
from grease gun head
How to Select Follower Position
( Fig 1 )
HOW TO BULK FILL BY SUCTION
Note:
Select the correct follower position (see Fig 1)
1) Lock follower (Fig 2)
2) Unscrew the barrel from the gun body 2 to 3 turns.
3) Pull the rod back and retain in barrel slot (Fig.4)
4) Unscrew the barrel from the gun body.
5) Release the follower rod from the barrel slot.
6) Insert the open end of the barrel into the grease, pull the
rod back slowly, and at same time push the barrel into the
grease, until the groove in the rod appears then push the
rod into the barrel.
( Fig 2 )
Note: When replacing cartridge or bulk filling,
ensure the high pressure/high volume
switch is positioned on “H”
