INSTALLATION
Standard installation
1: cut-off valve
2: Filter
3: Regulator
4: Lubricator
5: Control valve
6: Locking adapter
7: Hose reel
The above installation is not the integrated oil supply system, just contact the manufacture or
distributor if you need. Installation for air circle.
Note:
Do not hang any device at the air inlet, as there maybe dropping and damage.
Process
• Put the pump into lock adapter (Fig .3 Parts 6), Install to the trolley.
• Install cut-off valve (Fig3. Part1).
• Install filter (Fig 3. Part 2).
• Install regulator which control the speed and adjust the air pressure (Fig3. Part3).
• Install lubricator which with self-lubricate (Fig3. Part 4).
• Install control valve which control flux
，
When the speed is too fast, pump will be self-close
automatic to avoid pump be damaged (Fig.3 Parts5).
• Connect oil output.
OPERATION
Pressure Relief
Injury for skin:
Before pressure relief by manual
，
Pump is under pressure
。
To reduce the
risk of serious injury from pressurized fluid, accidental spray from the valve, or splashing fluid,
follow this procedure whenever you
• Are instructed to relieve pressure
• Stop dispensing
• Check, clean, or service any system equipment
• Install or clean dispensing devices
Pressure Relief procedure
• Turn off the cut-off valve, shut off air
• Put the pump to the waste equipments, switch oil valve ,relief pressure
• Turn the air supply and oil fluid.
• Turn off the oil valve.
When occurs
：
• Problems on control valve, flexible hose, rigid tube or manual tip, auto tip.
• Pressure not relieve thoroughly according to above relief procedure.
• Pressure relieved very slowly until relieved thoroughly. Please clear obstruction of oil system.
Note:
After initialize work, open the oil valve, pump start to work. Close the oil valve, pump
stop working.
Fig.3: Oil supply system installation
E3
TECHNICAL
DETAILS
EXPLODED AND
PARTS LIST
INSTALLATION
TROUBLE SHOOTING
SAFETY
INSTRUCTIONS
OPERATION
LIMITED
WARRANTY
WALL
INSTALLED
