995565 – Revision A
Page 20 of 38
9.3 – Control Box
In this section it will explain the correct procedure on removing and reinstalling the Control
Box for servicing procedures or replacement.
Removal
Step 1 – Remove Battery from the Stand Aid. (Refer to section 9.1)
Step 2 – Remove all the Cabling/leads from the Control Box. (Refer to section 9.2)
Step 3 – Use a 3mm Allen Key to remove the Screw fixing the Control Box to the Bracket
Step 4 – Lift the Control Box from its positioning on the Bracket to remove.
Refitting / Replacement
Step 5 - Refitting is a reversal of the removal process noting the following points:
A)
Ensure that the Control Box slides into position correctly and vertically straight onto
the Bracket for correct fitting.
