SW4000 USER’S MANUAL
VER5.13 27
4
5
6
1
2
7
3
8
Milling cutter may be flat-bottomed or arc-bottomed.
If flat-bottomed, set the tool diameter as 0;
B. Process XY plane
DRO provides the above 8 modes in processing
XY plane. The milling cutter is perpendicular to the
machine plane. DRO has internal ARC processing and
external ARC processing for each type:
External T +TOOL:
Internal T - TOOL.
Set the tool radius according to the actual milling
cutter when process XY plane.
Enter the following data for ARC processing:
TYPE 1 - 8 Mode of the ARC processing
* T+TOOL / T-TOOL Selection between T + TOOL / T - TOOL (This parameter is only
for XY plane)
RADIUS The radius of ARC that is to be processed
TOOL DIA Tool diameter
MAX CUT Feed step
Example 1:
Process an arc AB of 90
from point A to point B as
∘
the figure.
Parameters are as the following:
Machine plane XY
ARC mode type 3
T + TOOL
RADIUS 20mm
TOOL DIA 6mm
MAX CUT 0.5mm
Shrinkage is not taken into consideration.
Internal ARC
processing
(T-TOOL)
Tool compensation direction(when process XY plane)
External ARC
processing
(T+TOOL)
A
B
R20
A
