MachineryHouse CL-40A, Инструкция по эксплуатации

Страница: 34 / 93

33
7-2 Apron & Saddle
1) Filler hole location of Apron:
On the right platform of Saddle. The filler
hole has oil plug indicates “OIL”.
2) Drainer Hole location of Apron:
On the bottom cover of Apron, as illustrated left, position “A” (also can be seen in
front side of Apron downward)
3) Model No of Apron lubricant & change period
Model No is way oil. ISO UG 68, suggestion changing period is every half a year.
4) Adjustment for the loosely Half Nut Engaged Lever:
After long period of operation, the Half Nut Engaged Lever will get loose, please
adjust as per following steps:
a. Remover Thread Dial Indicator, there is four adjustment screws can be seen.
b. Adjust those four screws to proper pressure as soon as to push the lever.
c. Install Thread Dial Indicator back.
5) Feed load adjustment (cross feed & longitudinal feed):
There is a conical clutch “D” in the middle of Apron which is an overload protector
device. The capacity of safety load is about 12 kg. Appropriate load can be adjusted
by a hexagon socket screw in the middle of apron. Turn clockwise to increase load;
anti-clockwise it decrease. A proper load capacity can be tested by pressing
hand-wheel handle while auto feed operates to see if it wills automatically cut-off
when load is over 12 kg.
illustration 7-2-5
Page 34 Instructions Manual for CL-40A (L600) 01/09/2017