MachineryHouse AL-346V, Инструкция по эксплуатации

Страница: 44 / 82

- 42 -
Machine storage
If the machine is not properly prepared for storage, it may develop rust or corrosion. Use the recommendations in this
section to ensure that the lathe remains in good condition for later use.
To prepare your machine for short-term storage (up to a year):
1. Pump out the old cutting fluid, and remove and blow out lines with compressed air and a few drops of way oil.
2. Disconnect lathe from power!
3. Thoroughly clean all unpainted, bare metal surfaces, then apply a liberal coat of way oil.
4. Lubricate the machine as outlined in the lubrication section. Be sure to use the oil gun to purge all ball oilers and
the oil passages with oil.
5. Cover and place the machine in a dry area that is out of direct sunlight and away from hazardous fumes, paint,
solvents, or gas. Fumes and sunlight can bleach or discolor paint and make plastic guards cloudy.
6. Once or twice a month, depending on the ambient humidity levels in the storage environment, wipe down the
machine as outlined in step 3. Slide the carriage, tailstock, and steady rest down the lathe bed to make sure that
way spotting is not beginning to occur.
7. Every few months, manually rotate all gear driven components a few times in several gear selections. This will
keep the bearings, bushings, gears, and shafts well lubricated and protected from corrosion, especially during the
winter months.
To prepare your machine for long-term storage (a year or more):
1. Run the lathe and bring all gearboxes to operating temperature, then drain and refill the all gearboxes with fresh
oil.
2. Pump out the old cutting fluid, remove the lines, add a few drops of way oil into the lines, and blow out the lines
with compressed air.
3. Disconnect lathe from power!
4. Thoroughly clean all unpainted, bare metal surfaces, then apply a liberal coat of way oil, a heavy grease, or rust
preventative. Take care to ensure these surfaces are completely covered but that the rust preventative or grease is
kept off of painted surfaces.
5. Lubricate the machine as outlined in the lubrication section. Be sure to use the oil gun to purge all ball oilers and
the oil passages with oil.
6. Loosen or remove machine belts so they do not become stretched during the storage period. (Be sure to also affix a
maintenance note near the power button as a reminder that the belts have been loosened or removed.)
7. Place a few moisture-absorbing desiccant bags inside of the electrical box.
8. Cover and place the machine in a dry area that is out of direct sunlight and away from hazardous fumes, paint,
solvents, or gas. Fumes and sunlight can bleach or discolor paint and make plastic guards cloudy.
9. Slide the carriage, micrometer stop, tailstock, and steady rest down the lathe bed to make sure that way spotting is
not beginning to occur.
Page 44 Instructions Manual for AL-346V (L555D) 01/09/2017