MachineryHouse AL-346V, Инструкция по эксплуатации

Страница: 15 / 82

- 13 -
8. Move the feed direction lever (see Figure 2) to the disengaged middle position.
9. Turn the spindle speed control knob ( Figure 2 ) all the way counterclockwise (lowest speed) to avoid possibility of
a high-speed start.
10. Move the spindle speed range lever (
Figure 2 ) to the “ L ” position so the headstock is set in the low range
(70-440RPM). You may need to slightly rotate the chuck by hand to engage the lever.
11. Connect the lathe to power source, and then turn the main power switch to the
ON position ( Figure 3 )
12. Move the spindle ON/OFF lever to start the lathe. The spindle will rotate at 70 rpm. When operating correctly, the
machine runs smoothly with little or no vibration or rubbing noises.
— investigate and correct strange or unusual noises or vibrations before operating the machine further. Always
disconnect the machine from power when investigating or correcting potential problems.
13. Move the spindle ON/OFF lever to the center position,
and press the stop button.
14. Without resetting the stop button, move the spindle
ON/OFF lever down. The machine should not start.
—if the machine does not start, the stop button safety
feature is working correctly. Continue to the next step.
—if the machine starts (with the stop button pushed in),
immediately disconnect power to the machine. The stop
button safety feature is not working correctly. This safety
feature must work properly before proceeding with
regular operations. Call tech support for help.
15. Rotate the stop button clockwise until it pops out.
16. Make sure the lamp works.
Figure 2
17. Make sure that the cutting fluid nozzle is pointing toward the chip pan, then turn the cutting fluid pump switch
and open the nozzle valve. After verifying that cutting fluid flows from the nozzle, turn the cutting fluid switch OFF.
18. Start the spindle, and then step on the brake pedal. The power to the motor should be cut and the spindle should
come to an immediate stop.
SECTION 4
：
OPERATION
Operation overview
This overview is the basic process that occurs when operating this machine. Familiarize yourself with these steps to
better understand the remaining parts of the operation section.
To complete a typical operation, the operator does the following:
1. Puts on safety glasses, rolls up sleeves, removes jewelry, and secures any clothing, jewelry, or hair that could get
entangled in moving parts.
Page 15 Instructions Manual for AL-346V (L555D) 01/09/2017