215276
13
Revision A
3.2.1
Repositioning Conditioner Drive Speed Sensor
–
Model Year 2018 and Later
Reposition the speed sensor as follows:
NOTE:
This procedure also applies to model year 2017 headers that have an updated steel speed sensor and mounting bracket as
shown in Figure
.
1032990
A
C
B
Figure 3.16: Speed Sensor
–
Model Year 2018
and Later
1.
Remove nut (A) from sensor (B).
2.
Reinstall sensor (B) into hole (C).
1032992
A
C
B
A
D
E
Figure 3.17: Gap between Sensor and Pulley
3.
Make sure there is a 2
–
3 mm (1/16
–
1/8 in.) gap (A)
between pulley (B) and sensor (C). Adjust gap as required
using nuts (D). Make sure the sensor is parallel with the
pulley.
NOTE:
Additional vertical alignment of the sensor may be achieved
by moving the bracket up or down retaining nut (E). Loosen
nut (E), adjust bracket, and tighten nut (E) to 58 Nm
(43 lbf·ft).
4.
Tighten sensor nuts (D) to 12 Nm (9 lbf·ft).
Содержание R113
