![background image](http://html1.mh-extra.com/html/macdon/r1-series/r1-series_installation-instructions-manual_3196781030.webp)
214497
24
Revision D
1027672
A
B
Figure 3.38: Cutterbar
–
Bottom View
13. If shims (A) were removed during disassembly, install them
at this time.
NOTE:
The same number of shims must be installed on both sides
of the cutterbar. A maximum gap of 2 mm (0.08 in.) is
allowed.
14. Install two bolts with two washers (B) into end of cutterbar
through holes on the header frame. Snug bolts but do
NOT
tighten at this time.
NOTE:
These bolts are also used to secure the outboard rock
guard to the frame.
1027652
A
B
Figure 3.39: Alignment Tool on Gearbox
15. Remove bolts securing alignment tool (A) to drive hub (B).
Lift lower tube and remove tool.
1027250
A
Figure 3.40: Drive Alignment Tool (MD #325683)
16. Install bolt, washer, and nut (A) onto the drive alignment
tool for storage.