215627
110
Revision A
5.4
R2 Series Rotary Disc Header
This section details the procedures necessary to physically attach an R2 series rotary disc header to a windrower and to
attach its hydraulic and electrical connections.
5.4.1
Attaching Forming Shield
The forming shield controls the width and placement of the windrow.
$
%
&
Figure 5.91: Lynch Pin and Washer at Rear of
Windrower Leg
1.
Remove lynch pin (A) and washer (B) from straight pin (C).
$
%
&
'
Figure 5.92: Rubber Strap Securing Forming Shield
onto Windrower Leg
2.
Attach rubber strap (D) to straight pin (C) at the rear of the
windrower leg. Secure it with washer (B) and lynch pin (A).
3.
Repeat Step
to Step
at the
opposite side of the forming shield.
5.4.2
Attaching R2 Series Rotary Disc Header
The windrower may have an optional self-aligning hydraulic center-link, which allows control over the vertical position of
the center-link from the cab. If the windrower is so equipped, the procedure for attaching an R2 header will be slightly
different.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
