MacDon M1170NT5, Руководство оператора

Страница: 237 / 504

215922
217
Revision A
1019597
A
Figure 4.221: Draper Header QuickMenu
3. Turn the knob to scroll to DRAPER setting (A) on the
QuickMenu, and press the knob to select it. The next
page opens.
1023089
A
Figure 4.222: Draper Header Draper Page
4. Scroll to DEFAULT DRAPER ALARM PRESSURE (A), and
select it.
5. Change the alarm set-point by scrolling. Scrolling past the
highest setting turns off the alarm. When the alarm point is
off, the digital value is replaced with three dashed lines.
6. Adjust the draper alarm pressure set-point to the
desired value, and press the knob to select it.
NOTE:
Factory setting is 19,995 kpa (2900 psi).
Draper Slip Warning
A slipping draper can severely damage the draper belts. Slippage is typically caused by debris inside the draper.
1019524
A
Figure 4.223: Draper Slip Warning
If the left or right draper idler roller begins to slip, a warning
tone will sound and one of the following messages (A) will
appear on the Harvest Performance Tracker (HPT) screen:
•
Left draper slipping. Disengage header.
•
Right draper slipping. Disengage header.
The Operator cannot cancel the message.
NOTE:
A draper slip sensor failure will disable the sensor and a fault will
appear on the Harvest Performance Tracker (HPT) screen.
Contact your MacDon Dealer for service.
NOTE:
The draper slip warning is disabled when a double draper drive
kit is installed.
OPERATION