UNLOADING AND ASSEMBLY
169558
Revision
D
21
STEP 9. INSTALL AM/FM RADIO
Provision has been made for installation of
AM/FM radio. The mounting is designed to fit a
DIN E style radio with a depth
X
= 161 mm, and
having a 5 mm threaded stud centered on the
rear for support. Provision has been made for
adjustments should the radio fall outside these
parameters.
a. Ensure the ignition is turned to OFF.
b. Remove radio panel by removing four screws
(A).
c. Remove screw and nut (C) to remove support
(D) from panel. Retain metric nut (E) and
lockwasher.
d. Remove the cut-out by cutting the tabs (B) in the
panel. Remove sharp edges on panel.
e. Locate receptacle (F) (supplied with radio) in
opening, and secure by bending tabs (G) on
receptacle against panel.
f. Insert radio into receptacle, and attach radio
bezel. Ensure radio locks into position, and
faceplate (H) is against the panel.
g. A six-pin connector for the radio is included in
the wiring harness.
In order to mate properly with this connector, the
radio must have a six-pin connector (Packard
#2977042), and have a terminal arrangement as
follows:
h. Attach two additional wires in the wiring harness
to the radio:
1.
CIRCUIT 503
- Red with 1/4 in. female blade
terminal. This is a live wire provided for
powering a radio clock/memory, if these
exist on your radio.
2.
CIRCUIT 315
- Black ground wire attaches
to radio body.
i.
Plug cable from antenna into radio.
NOTE
An approved radio package is
available from Radio Engineering
Industries (REI) of Omaha, Nebraska.
(continued next page)
C
E
D
B
X
A
H
G
F
