MacDon HC10, Оригинальная инструкция

Страница: 91 / 242

215126
69
Revision A
4.9.3 Checking and Adjusting Roll Timing
1005061
A
B
C
Figure 4.33: Roll Timing Tool
A - Crop Direction B - Timing Gap
C - Roll Timing Tool
For proper conditioning, the rolls must be properly timed and
aligned; each steel bar on one roll must be centered between
two bars on the other roll as shown in illustration at right. The
factory setting should be suitable for most crop conditions.
1. Check rolling before adjusting. Refer to 3.12.3 Checking Roll Timing, page 48 .
If roll timing needs adjusting, continue to the next step.
1005063
A
A
Figure 4.34: Timing Gear
2. Loosen four bolts (A) on one of the small timing gears.
3. Insert tool as described above and allow rolls to adjust to
the tool.
4. Tighten bolts on timing gear.
5. Return the tool the storage location on the right end of the
conditioner. Secure it with a washer and wing nut.
OPERATION