MacDon HC10, Оригинальная инструкция

Страница: 70 / 242

215126
48
Revision A
3.12.2 Checking Roll Gap
1005156
A
B
Figure 3.69: Roll Gap
A - Crop direction B - Roll gap
1005125
A
Figure 3.70: Roll Gap Gauge
1. Confirm the roll gap is set to the factory setting using either
method below:
•
Refer to Figure 3.69, page 48 : Confirm the roll gap (B) is
20 mm (3/4 in.).
•
Refer to Figure 3.70, page 48 Confirm the roll gap is at
the 1.5 line (A).
Gauge readings should be the same at both ends of the roll
2. If roll gap requires adjusting, refer to 4.9.2 Adjusting Roll
Gap, page 68 .
3.12.3 Checking Roll Timing
To check the roll timing, follow these steps:
1005062
A
B
Figure 3.71: Conditioner End
–
Right
1. Remove wing nut and washer (A) and remove tool (B) from
panel at right end of conditioner.
UNLOADING AND ASSEMBLY