![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032138.webp)
214685
126
Revision A
Figure 6.38: Balance Linkage
13. Move wing downward with torque wrench (A) until the
pointer
’
s upper alignment tab (C) lines up with the lower
edge of the top-link (B). Observe indicator reading (A)
on the wrench and record it.
14. Compare the readings taken in Steps
and
.
•
If the difference between the readings is 0.5 or less,
the wing is balanced and no further adjustment is
required. To reinstall the linkage cover, refer to Steps
and
•
If the difference between the readings is more than
0.5, the wing is not balanced. Refer to
Adjusting Wing Balance, page 128
.
Figure 6.39: Wrench Indicator
•
If the indicator range is as shown, the wing is
too light.
Содержание FlexDraper FD1 Series
