MacDon FFT FD75, Руководство по сборке

Страница: 101 / 308

214325
91
Revision A
4.3 Checking Knife Drive Box
To access knife drive box, endshield must be fully opened.
Figure 4.2: Left Endshield Open
1. Fully open endshield(s) for access to knife drive box.
Refer to
3.4.5 Opening Endshield, page 83 .
Figure 4.3: Knife Drive Box
IMPORTANT:
The knife drive box breather is shipped in position (A)
(forward) to prevent oil loss during transport. The
breather plug
MUST be repositioned to location (B) to
prevent oil loss during normal operation. Failure to do so
can result in damage to knife drive box.
2. Check position of plug (A) and breather (B) at knife
drive box. Position
MUST be as shown. Reposition if
necessary.
3. Check oil level. It should be between lower hole (C) on
dipstick and bottom end of dipstick. If necessary, add
oil. Use clean SAE 85W-140 lubricant.
IMPORTANT:
Check oil level with top of knife drive box horizontal.
4. Close endshield(s). Refer to 3.4.9 Closing Endshield,
page 87 .
IMPORTANT:
If header has dual knife drive (DKD), repeat on
opposite side.
PERFORMING PREDELIVERY CHECKS