![background image](http://html.mh-extra.com/html/macdon/d50/d50_operators-manual_685672203.webp)
169441
191
Revision D
ϭϬϯϵϵϴϳ
A
B
Figure 4.144: Motor End of Drive Roller
3.
Secure the motor with shoulder bolts (B), and tighten. The
shoulder bolts allow clearance between the motor and arm.
The motor is not secured tightly to the arm.
4.
Push the roller against the shoulder on the motor shaft, and
hand-tighten the two set screws (A). Torque the set screws
to 27 Nm (20 lbf·ft).
1001588
A
5.
Torque bolt (A) to 95 Nm (70 lbf·ft).
6.
Reattach draper. For instructions, refer to
7.
Adjust draper tension. For instructions, refer to
Adjusting Draper Tension, page 181
.
8.
Readjust the hydraulic motor hoses (if required), and
tighten the hose clamps.
9.
Run the machine, and adjust tracking if required. For
instructions, refer to
4.9.6 Adjusting Draper Tracking, page
Removing Draper Idler Roller
The feed draper idler roller needs to be removed when repairing or replacing it.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
NOTE:
If the draper joint is not visible, engage the header until the connector is accessible (preferably close to the outboard end
of the deck).
1.
Start the engine.
2.
Raise the header fully.
3.
Raise the reel fully.
Содержание D50
Страница 101: ...169441 89 Revision D 10 Tighten bolts B OPERATION ...
Страница 124: ......
Страница 295: ...topsoil moisture 83 types 80 weather and topography 83 WOT definition 19 INDEX ...
Страница 296: ......