UNLOADING AND ASSEMBLY
Form # 169007
Model Year - 2009
15
p. Connect header drive hydraulics (L) and
electrical harness (M) to header as follows:
1. Check connectors and clean if required.
2. Push hose connector onto mating receptacle
until collar on receptacle snaps into lock
position.
3. Remove cover on electrical receptacle.
4. Push electrical connector onto receptacle
and turn collar on connector to lock it in
place.
5. Attach cover to mating cover on tractor
wiring harness
q. Connect reel hydraulics (N) as follows:
1. Open cover (O).
2. Check connectors and clean if required.
3. Push in lock button (P) and pull handle (Q)
to full open position.
4. Position connector from tractor onto
receptacle and push handle (Q) to engage
pins on connector.
5. Push handle to closed position until lock
button (P) snaps out.
6. Raise and lower header and reel a few times
to allow trapped air to pass back to the
reservoir.
NOTE
It is not necessary to bleed the system by
loosening fittings.
KNIFE DRIVE
DRAPER DRIVE
RETURN
CASE DRAIN
(DOUBLE KNIFE)
ELECTRICAL
M
L
HEADER DRIVE HOSES
N
O
P
Q
REEL HYDRAULICS