215184
206
Revision A
1001475
A
B
Figure 7.2: Float Module
WARNING
Never start or move the machine until you are sure all
bystanders have cleared the area.
3.
Start the engine and slowly approach the header until the
feeder house is directly under float module top cross
member (A) and alignment pins (C) (refer to Figure
) on the feeder house are aligned with holes (B) in
the float module frame.
1014361
C
Figure 7.3: AGCO Group Alignment Pins
NOTE:
Your combine feeder house may not be exactly as shown.
1001491
A
Figure 7.4: Feeder House and Float Module
4.
Raise the feeder house slightly to lift the header, ensuring
feeder house saddle (A) is properly engaged in the float
module frame.
5.
Shut down the engine, and remove the key from
the ignition.