215184
142
Revision A
3.6.2
Forged Hold-Down
–
Stub Guard Only
1014358
A
B
Figure 3.303: Cutterbar Wearplates
1.
If equipped, position cutterbar wearplate (A) on the
cutterbar and install with two 7/16 in. x 1-1/2 in. long
carriage bolts (B).
1009656
C
D
A
B
Figure 3.304: Stub Guard
2.
Place adjuster plate (D) and hold-down (A) on cutterbar as
shown and secure with 7/16 in. hex nuts (B). Adjuster
bolt (C) should
NOT
require adjusting.
3.
Repeat the previous steps for the second (adjacent)
location.
4.
Torque nuts to 72 Nm (53 lbf
∙
ft).
If the header is to be assembled at one location and then transported to a MacDon dealership, proceed to
Header for Transport to Dealership, page 143
.
If the header is being assembled at the MacDon dealership, proceed to