UNLOADING AND ASSEMBLY
169078
19
Revision E
2. Without the self-alignment kit, re-locate the
pin (G) at the frame linkage as required to
raise the center-link (E).
d. Slowly drive windrower forward so that feet (H)
on windrower enter boots (B) on the header.
Continue to drive slowly forward until feet
engage the boots, and header nudges forward.
e. Connect the center-link. Refer to the section for
your equipment type:
HYDRAULIC LINK WITH OPTIONAL
SELF-ALIGNMENT KIT
1. Adjust position of the center-link cylinder (E)
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on
the GSL to position the hook above the
header attachment pin.
IMPORTANT
Hook release (J) must be down to
enable self-locking mechanism. If the
release is open (up), manually push it
down after hook engages header pin.
2. Lower the center-link onto the header with
REEL DOWN switch until it locks into
position (hook release (J) is down).
3. Check that center-link is locked onto header
by pressing the REEL UP switch on the
GSL.
4. Proceed to step f. on next page.
(continued next page)
J
HEADER UP
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER DOWN
E
G
H
B
E
J
Содержание A30-S
Страница 55: ...NOTES 169078 53 Revision E ...