MacDon 2000-B, Руководство оператора

Страница: 20 / 31

Form 46240
18
Issue 06/06
TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTION REF.
CUTTING ACTION & SICKLE COMPONENTS
Ragged or uneven cutting of
crop. (continued) Cutting edge of guards
not close enough or
parallel to sickle
sections.
Align guards. *
Tangled or tough to cut
crop.
Install stub guards. *
Reel too far back. Move reel forward. *
Loose sickle drive belt. Adjust drive belt tension. *
Sickle plugging. Reel too high or too far
forward.
Lower reel or move reel
rearward. *
*
Ground speed too slow. Increase ground speed. *
Loose sickle drive belt. Adjust drive belt tension. *
Improper sickle hold-
down adjustment.
Adjust hold-down so sickle
is held against guard cutting
surface. *
Dull or broken sickle
sections.
Replace. *
Bent or broken guards. Align or replace. *
Reel fingers not lifting
crop properly ahead of
sickle.
Increase finger pitch
aggressiveness. 14
Steel pick-up fingers
contacting sickle.
Increase reel clearance to
cutterbar. *
Header float too heavy. Adjust float springs for
lighter float. *
Mud or dirt build-up on
cutterbar.
Raise cutterbar by lowering
skid shoes. *
Flatten header angle. *
Sickle is not operating at
recommended speed.
Check engine speed of
windrower. *
* See your Header or Power Unit Operator's Manual.