MacDon 2000-B, Руководство оператора

Страница: 19 / 31

Form 46240
17
Issue 06/06
TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTION REF.
CROP LOSS AT CUTTERBAR (continued)
Crop not being cut at ends. Reel too high or not
centered in header.
Lower reel or adjust
horizontal position. *
*
Sickle hold-downs not
adjusted properly.
Adjust hold-downs so sickle
works freely, but still keep
sections from lifting off
guards. *
Sickle sections or guards
are worn or broken.
Check and replace all worn
and broken cutting parts. *
Header is not level. Level header. *
Reel fingers not lifting
crop properly ahead of
sickle.
Increase finger pitch
aggressiveness. 14
Divider runs down thick
crop at ends, prevent-ing
proper feeding.
Replace 3 or 4 end guards
with stub guards. **
CUTTING ACTION & SICKLE COMPONENTS
Ragged or uneven cutting of
crop.
Sickle hold-downs not
adjusted properly.
Adjust hold-downs so sickle
works freely, but still keep
sections from lifting off
guards. *
Sickle sections or guards
are worn or broken.
Check and replace all worn
and broken cutting parts. *
Sickle is not operating at
recommended speed.
Check engine speed of
windrower. *
Ground speed too fast
for reel speed.
Reduce ground speed or
increase reel speed. *
*
Reel fingers not lifting
crop properly ahead of
sickle.
Increase finger pitch
aggressiveness. 14
Cutterbar too high. Lower cutting height. *
Header angle too flat. Steepen header angle. *
Bent sickle, causing
binding of cutting parts.
Straighten a bent sickle.
Align guards. *
*
* See your Header or Power Unit Operator's Manual.
** See your dealer.