QUICK SETUP
Install an air system
Your marker can accept any standard screw in air
system. A pressure of 450psi is preferred, however
300-800psi is acceptable.
1. Unscrew the ASA cap by 3 turns
2. Screw in an air system
3. Screw the cap back in to engage the air.
WHEN SCREWING YOUR
AIR SYSTEM INTO THE ASA,
THE THREADS SHOULD BE
LOOSE. IF AT ANY POINT
THEY BECOME TIGHT, DO
NOT FORCE THE THREADS,
THIS MAY CAUSE DAMAGE
TO YOUR AIR SYSTEM OR
YOUR MARKER!
1
3
8
2
Fit your loader
1. Open the lever
2. Push in your loader
3. Close the lever
4. Make fine adjustments to the clamp force using a
hex key tool.
Use any loader you like with the elec frame version, your mark-
er will use the beam sensor to wait for a ball before firing. If
you would like to fire at a faster rate, use a faster loader. When
using the mech frame accessory, use a fast leader, because the
beam sensor is not used.
1
3
2
4
