MACDEV Gladiator inLine REG, Руководство пользователя

Страница: 3 / 10

Installation
Air Fitting Installation:
Your Gladiator inline reg comes ready to have an air tting
installed. To correctly install your air tting follow these steps.
NOTE: failure to follow these instructions may
result in damage to your Gladiator – this is not
covered under warranty!
Step1: Unscrew the two halves of your Gladi-
ator (by hand) as shown in gure 1. NOTE:
There is a white grease on the threads inside
your Gladiator – do not wipe this off.
Step 2: Remove the seat,
main valve and main valve
spring as shown in gure 2.
Set them aside so that they
remain clean.
Step 3: Use a wrench to hold
the Gladiator bottom works in
place as you tighten the air
tting into place (as shown in
gure 3). Do not over tighten the air tting, and use a snug
wrench on the Gladiator bottom works to prevent scratching.
Figure 1
Figure 2
Figure 3