macc SPECIAL 411 CSO, Инструкция по эксплуатации

Страница: 13 / 37

5. MAIN TECHNICAL DATA
Under no circumstances should the following data be altered , this is in order to protect the correct functioning
of the machine and to avoid creating safety risks for the operator .
Three phase power supply
Motor power 0.9 - 1.6 kW
Motor revolutions 700 - 1420 rpm
Gearbox reduction ratio i = 1 : 20
Cutting speed 38 - 77 m/1’
Electric pump 0.06 kW
Fly wheel dimensions 350 mm
Blade size ( length x width x thick ) 3200 x 27 x 0.9 mm
Cutting thickness 1,2 mm
Cutting angle 60° dx – 45° sx
Material clamping vice max opening 400 mm
Jaws height 150 mm
Jaws length 210 mm
Bed height 950 mm
Coolant tank capacity 15 litri ~
Machine weight ~5195 N ( 530 kg )
6. HANDLING AND TRANSPORTATION
For safe handling and transportation use a lift truck for movement indoors also indicated on the Drawing 3 Encl.2 . Keep
the machine in its normal position and avoid turning it upside down .
If the machine is fastened to the pedestal ,
stability will be greatly reduced and therefore all the necessary measures should be taken to stop the machine
from tipping over .
All handling and transportation operations should be carried out by trained staff .
7. MACHINE INSTALLATION
A. MACHINE CHECK
The machine should be checked to make sure that it has not been damaged during transportation and handling . If the
machine appears to have been damaged , contact MACC immediately . Fit all the supplied accessories onto the
machine such as the bar-stop 116 and the roller arm 54 ( DRAW.4 ENCL.2 ) .
B. FASTENING OF THE MACHINE
The machine will be able to operate in keeping with the technical parameters supplied by MACC if it is
positioned correctly and fastened securely to the bench or the factory floor so that vibrations are minimal
during operation . Consult drawing 4 SPECIAL 411 CSO Installation plan Encl.2 .
C. BAND ASSEMBLY
Remove the bow guard 2 by unscrewing the screws ( DRAW.11 ENCL.5 ) . Fit the band by inserting it first between the
bearings of the blade guide heads and then on the two pulleys , tighten the blade slightly by means of the hand wheel
28 and replace the bow guard . Check that the band is fitted with the correct direction of teeth , as shown in drawing 5-6-
7 enclosed document 3 . Make sure that the band type ( dimensions 3200x27x0.9 ) and its teeth pitch are suited to the
material to be cut .
D. ELECTRICAL CONNECTION TO THE MAINS
Install a differential thermomagnetic switch with characteristics suited to the mains .
3