MacAllister MSPS1200, Давайте начнем

Страница: 16 / 42

16
MSPS1200 by MACAllister
Before you start
Connecting rods for track
Using the track connectors supplied in the track pack, you can connect lengths of
track for long cuts. Each track connector (d) comprises a spacer (a) and an
expansion bar(b) with four hex screws (c).
Assemble each connector by fitting the spacer (a) to the side of the expansion bar
(b)opposite the heads of the hex screws as the Fig. 6 shown.
c
b
a
d
Fig. 6
1.
Thread one track connector into the upper clamp channel (on the face of a
length of the track).
2.
Ensure that the heads of the hex screws are facing away from the track and
therefore accessible.
3.
Position the connector half way into the channel, so that one of hex screw is
within the channel and exposed.
NOTE :
Before first use and from time to time as needed, apply a light
spray of lubricant so that the saw will glide smoothly along the length of
the track. Do not allow dust, shavings or other debris to build up on the
track.
Get
ting
st
arted
...