31
MSDD18-Li-2
In
more
detail
. . .
Troubleshooting / Recycling and disposal
Problem
Possible cause
Solution
1. Product does
not start
1.1. Forward / reverse rotation
control switch at center
lock position
1.2. Battery pack not properly
attached
1.3. Battery pack discharged
1.4. Battery pack damaged
1.5. Other electrical defect to
the product
1.1. Push forward / reverse
rotation control switch to
left / right
1.2. Attach properly
1.3. Remove and charge
battery pack
1.4. Check by a specialist
electrician
1.5. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Battery pack capacity too
low
2.2. Air vents are blocked
2.1. Charge battery pack
2.2. Clean the air vents
3. Unsatisfactory
result
3.1. Driver/drill bit is worn
3.2. Driver/drill bit not suitable
for intended operation
3.1. Replace with a new one
3.2. Use suitable driver/drill bit
4. Product
suddenly
stops
4.1. Product overloaded
4.2. Battery pack discharged
4.3. Battery too hot
4.1. Remove the product from
the workpiece and switch
it on again
4.2. Remove and charge
battery pack
4.3. Remove battery pack and
let it cool down
Recycling and disposal
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local Authority or local store for
recycling advice.
Disposal of an exhausted battery pack
To preserve natural resources, please recycle or dispose of the battery pack
properly. Consult your local waste authority for information regarding available
recycling and/or disposal options. Discharge your battery pack by operating your
tool, then remove the battery pack from the tool and cover the battery pack
connections with heavy duty adhesive tape to prevent short circuit and energy
discharge.
Do not attempt to open or remove any of the components.
