16
GB
IE
MTSP800A by
MAC ALLISTER
In more detail...
Start the machine (Fig. 12)
Intended use
This table saw is designated with a rated input of 800 Watts. This product is
intended for cutting wood and similar material e.g. MDF and chipboard.
This product should not be used on other materials or those harmful to health.
It is to be used for dry operation only without water or other cooling liquids.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Operation
Fig. 13
Switching on:
> To start the machine by pressing the green I button (11-a) on the On/Off switch (11).
When turning the switch ON stand on either side of the blade and never in front of it.
Allow saw blade to reach full speed before cutting.
Switching off:
> To stop the machine by pressing the red 0-Button (11-B) on the On/Off Switch (11).
Bevel locking screw (Fig. 13)
> The bevel locking screw (
8
) locks the blade in the desired tilting angle. To loosen
turn it anti-clockwise. When setting the angle of the cut fully loosen it.
> The saw blade can be adjusted steplessly between 0° and 45°.
> The bevel locking screw (8) is used to tilt the blade for bevel cutting.
> Before turning the table saw ON, be sure it is securely tightened so that the
blade will not shift during the table saw operation.
11-a
11-b
Fig. 12
8
