FR
IE
Getting
started...
11
Getting started...
MTSP800A by
MAC ALLISTER
Before you start
> Turn the bevel locking screw (8) and set the saw blade to 0° and lock the bevel
locking screw (8).
> Unscrew the fixing screws (19) and remove bottom guard (6).
> Undo the nut (20) with spanner (18) on the nut itself and multi-spanner (17) on the
saw shaft to apply counter-pressure and remove nut (20) and outer flange.
> Place one new blade (15)] on arbor shaft. Make sure saw blade teeth point down at
the front side of saw table. Place outer flange and arbor nut on arbor shaft and verify
that large, flat surface of the outer flange faces the saw blade and the saw blade (15)
is firmly seated aganist the inner flange.
Tighten the nut (20) using spanner (18) and
multi-spanner (17). Re-assemble the bottom guard (6) using fixing screws (19).
Assembling the saw blade(Fig. 1-2)
Caution! Pull out the power plug.
Caution! Turn the nut in the direction of rotation of the saw
blade (15).
Caution! Note the direction of rotation (see arrow on the
saw blade).
Fig. 1
20
Loosen
Tighten
17
15
18
19
6
Fig.2
