EN
EN
24
25
Getting started...
Getting started...
MPS750S-2
MPS750S-2
Saw chain and guide bar
1. Use only a guide bar (13) and saw chain (14) according to the
technical data of the pole saw.
2. Place the product on a suitable flat surface with the side cover (12)
facing upwards.
3. Unscrew the locking wheel (19) in direction and then remove it
together with the side cove (12). (Fig.5)
Fig. 5
4. Spread the saw chain (14) out with the cutting edges of the chain
pointing in the direction of rotation.
Slide the saw chain (14) into the groove around the guide bar (13).
Ensure saw chain (14) is installed in correct direction of rotation.
(Fig.6)
Fig. 6
WARNING! The direction of the saw chain ‘cutters’ must
be same as indicated by the symbol and arrow on the
guide bar!
Before you start
Before you start
5. Align saw chain (14) and the guide bar (13) assembly with the drive
sprocket (28) and the mounting bolt (26). Lay the saw chain (14)
around the drive sprocket (28) and then lower the guide bar (13) to
install it to the mounting bolt (26). (Fig.7)
Fig. 7
6. The saw chain movement is as indicated by the arrow (Fig.8). Make
sure the saw chain (14) is properly placed over the sprocket wheel
(15) of the guide bar (13). (Fig.8)
Fig. 8
